Every airtight woodstove and fireplace insert has braided fibreglass rope installed around the door edge for a tight seal. Eventually, when it gets brittle or starts falling out, or when closing the air vents won’t throttle back your fire anymore, it’s time to replace the rope.
You’ll pay less than $20 for a new rope gasket and high-temperature adhesive at hardware stores and building centres. Buy more than enough rope to go around the perimeter of your door. When the stove is cold, pull the old gasket out of the groove, then use a putty knife or a slot screwdriver to remove any remaining adhesive.
Cottage Q&A: Do I need to get my woodstove inspected?
Get help to hold the new rope in the door groove without glue. Then, with scissors, cut the rope precisely to length so both ends meet near the top corner of the hinge side with no gap or overlap. Avoid pulling the rope as you measure and install it—the weave should stay full and loose.
Remove the rope, brush a generous layer of glue into the groove using a plumber’s flux brush, reinstall the rope, and then close the door, and leave it overnight to dry before starting a fire. Your door will seal properly for years.
This article was published in the March/April 2024 issue of Cottage Life.
Related Story Three tricks to “age” new wood
Related Story Key closing-up chores that you never want to forget
Related Story This season’s hottest grilling accessory? Flat-top griddles
The post Woodstove heating inefficiently? Here’s a simple fix appeared first on Cottage Life.